Message #394251

[charles]

 lance, there was a guy askn bout how to inset a "ma-duce" ejector/primer base into a knife handle. that got me to thinkn about using a 30mm or a 25mm casing for a handle. whats your thoughts? i could put it in a vise to flatn out the roundness to make it more handle like, but i like to be unique. it would slicker than owl poo on a hickery limb, what could i use to rough up the casing if it was left round? i dont have a lathe to run a checkering wheel over it, so what could i use instead?