|
chestonmcdowell
|
 |
« on: October 06, 2012, 09:32:53 pm » |
|
How to put a 50 cal casimg into a knife hanlde, only the end paer any ideas
|
|
|
|
|
Logged
|
Mathews mission venture
|
|
|
|
Lance
|
|
« Reply #1 on: October 06, 2012, 10:21:35 pm » |
|
Cut the end off with a hacksaw. Get a drill bit just a little bigger than what you are setting in the handle. Drill a hole just deep enough for the casing head to almost be flush with the handle and epoxy it in the hole with a good high tensile strength two part epoxy. Make sure you give it plenty time to set up before handleing.
|
|
|
|
|
Logged
|
A scared dog dont get no meat !
|
|
|
|
WayOutWest
|
|
« Reply #2 on: October 07, 2012, 09:38:50 am » |
|
You may want to use an arbor bit as they leave a flat surface to epoxy to.
|
|
|
|
|
Logged
|
|
|
|
|
